Setting the Satellite Carrier Parameters
To configure the satellite receiver to the proper satellite carrier, please perform the following steps:
- From the receiver front panel or on the remote control, press the Menu button.
- On the Main Menu screen, use the arrow buttons to navigate to the Setup Menu and press the Select button if using the front panel or OK if using the remote.
- On the Setup Menu, navigate to Tuning / Preset and press Select/OK.
- On the Tuning / Preset screen, navigate to the desired parameter by using the arrow buttons. Pressing Select/OK will put the selected field in edit mode.
- Use the Satellite Parameters chart to determine the correct parameters to enter for the specific Satellite for your area.
- The following fields have predefined parameters to choose from by using the Left/Right arrow:
- Modulation Type: DVB-S or DVB-S2
- LO Select: On, Off, or Auto
- LNB Power: 18-H, 13-V, Off, H-NIT, or V-NIT
- DiSEqC: Enable or Disable
- The following fields require manual entry of parameters by using the Up/Down and Left/Right arrows:
- Downlink (in GHz)
- Symbol Rate (in MS/s)
- NetId
- LO Freq 1 (in GHz)
- LO Freq 2 (in GHz)
- Crossover
- The following fields have predefined parameters to choose from by using the Left/Right arrow:
- After all the parameters are entered, push the green button on the remote or navigate to the Save icon and press Select/OK to save your settings.
- If the parameters where entered correctly, you should see a box that says "Acquisition Success. Do you want to save the changes?" Make sure Continue is selected and press Select/OK. You then can Exit the screen.
CHURCH SATELLITE PARAMETERS.pdf